BY-PASS FILTERS & SYSTEMS

 

 

     
      

  

 

  

 

 

 

 

 

BY PASS HYDRAULIC FILTER

 

 

 

 

The Kleenoil "high pressure" oil filter can be fitted on the "by pass" basis to hydraulic systems, compressors, or any system with oil at pressure up to 3000psi.

The flow through the Kleenoil filter is controlled to approx. 4ltrs per minute at 40psi. A flow rate which is low enough to have negligible effect on most "system pressures", yet high enough to ensure that oil is being kept in "as new" condition.

                                  

 

More than 70% of Hydraulic Failures are caused by 

contaminants in the oil

Find Out More......

 

 

 

 
 

     

 

 

    HDU 9778  SDU 9788  
Fitted with Cartridge   HDC1878   SDC 1888
Suitable for tanks        upto 540 ltrs  upto 1360 ltrs

Water retention

(down to<0.05%)   

0.56ltrs  1.2ltrs
Technical Specs   165X168mm    180X212mm

 

 

 

 

SALIENT FEATURES:

 

  Removes contaminant particles down to less than 0.5 microns

  Removes water content from oil to less than 0.25% up to capacity of cartridges

  Prevents corrosion of components

  Reduces component wear (seals, piston rods, pumps etc.)

  Reduces the incidence of sticking & worn value components

  Extends life of in-line OEM filters and components.

  End to the need to change hydraulic fluids

  All properties of oil being cleaned are maintained

  Filter cartridge can be changed within minutes.

  Can easily be removed and re-installed on replacement equipment

  Simple to install

  Used in transport and industry world-wide

  Can be used with virtually any petroleum/synthetic based oil

  Greatly reduced collection of waste oil by disposal companies

 

 

 

KLEENOIL HYDRAULIC BLOCK FITTED WITH  PRESSURE REDUCING VALVE 

 

The Kleenoil Hydraulic Block is mounted to the bottom of the Kleenoil Bypass Filtration System to convert the lower pressure bypass engine oil filter to a high pressure hydraulic fluid filter.

There are three ports on the valve block as listed:

Port 1: Low Pressure output approximately 50 PSI normally is blanked off but may be used to supply another   

  filter housing

Port 2: High pressure input up to 3000 PSI

Port 3: Return to hydraulic reservoir. This port is fitted with adaptors size No. 6 JIC and it is important that the return hose is of at least 3/8" bore

                                                                                                        © 2009 Kleenoil Filtration Ltd. All Rights Reserved. Terms of Use.