The Kleenoil "high pressure" oil filter can be fitted on the "by pass" basis to hydraulic systems, compressors, or any system with oil at pressure up to 3000psi.

The flow through the Kleenoil filter is controlled to approx. 4ltrs per minute at 40psi. A flow rate which is low enough to have negligible effect on most "system pressures", yet high enough to ensure that oil is being kept in "as new" condition.

HEAVY DUTY

Code 9778 Heavy Duty Filter Unit and Code 1878 Heavy Duty Cartridges

i. For hydraulic systems with tanks upto 540 ltrs;

Specifications:

Water retention (down to less than 0.05%): 0.56ltrs.

Height: 165mm; Diameter:168mm           

SUPER DUTY

Code 9788 Super Duty Filter Unit and Code 1888 Super Duty Cartridges

i. For hydraulic systems with tanks upto 1360 litres;

Specifications:

Water retention (down to less than 0.05%) : 1.2 ltrs.

Height: 180mm; Diameter: 212mm

                                            SEE FITMENTS (CLICK ON IMAGE TO VIEW)                                                       

SALIENT FEATURES:

Removes contaminant particles down to less than 0.5 microns

Absorbs water content.

Prevents corrosion of components

Reduces component wear (seals, piston rods, pumps etc.)

Reduces the incidence of sticking & worn value components

Extends life of in-line OEM filters and components.

End to the need to change hydraulic fluids

All properties of oil being cleaned are maintained

Filter cartridge can be changed within minutes.

Can easily be removed and re-installed on replacement equipment

Simple to install

Used in transport and industry world-wide

Can be used with virtually any petroleum/synthetic based oil

Greatly reduced collection of waste oil by disposal companies

The Kleenoil Hydraulic Block is mounted to the bottom of the Kleenoil Bypass Filtration System to convert the lower pressure bypass engine oil filter to a high pressure hydraulic fluid filter.

There are three ports on the valve block as listed: