The filter is installed into a vertical section of pipeline

Fluid enters the central inlet where the fluid contacts a centrally located diverter tube were it is dispersed down the inside of the filter body

The fluid passes through the top half of the filter and into the bottom half where the magnet elements reside and collect the contamination

Fluid exists the central outlet spout.  - Total magnetic length covered 205mm

205mm magnet length

No controls supplied

High flow speed – Bad

Difficult to maintain

Expensive to install

Fluid expertise required

Low collection capacity

Filter support required

High air consumption

Non magnet sensing

The filter is installed into a horizontal section of pipeline

Fluid enters the first chamber via the side inlet where the fluid contacts the first array of magnetic elements, fluid moves vertically upwards and over the internal chamber wall and into the second chamber. – Total magnetic length covered 780mm, 3 x more!!

780mm magnet length

Fully controls supplied

Slow flow speeds – Good

Easy to maintain

Cheap to install

No expertise required

High collection capacity

Floor mounted

Low air consumption

Magnet sensing included